Ge Stackable Washer Dryer Lid Won T Lock

If it still won t budge proceed to plan b.

Ge stackable washer dryer lid won t lock.

If there is a pause in the washer cycle the controls will lock up. If the washer was stopped before the cycle was complete. Find the information you are looking for in videos faqs tips and more. So at work we have a stacked ge washer dryer.

A power failure or if it was put in the test mode at the factory. If the washer fills but won t start the agitation cycle the lid lock switch could be defective. No water coming out nothing. To find the correct replacement part.

If the door lock is defective the washer door will not latch properly. The top dryer is working fine the lower washer does nothing when you close the lid. Door lock motor and switch assembly the door lock secures the washer door shut during operation. The pause can occur because of the following.

Let the washer sit unplugged for about 10 minutes then try lifting the lid. Hi all you guys helped me before. Most washers will have a manual release to unlock the mechanism and allow you to open the door or lid. If it opens you re all set.

I inspected it and looked inside and saw that. Ge appliances the site navigation utilizes arrow enter escape and space bar key commands. Once the washer door is closed the washer can begin operating. The lid lock mechanisms on some washers are heat activated which means overriding them is as simple as letting them cool off.

Left and right arrows move across top level links and expand close menus in sub levels. The release is normally accessible from below the door lock or on some models from inside the soap dispenser housing. If the door or lid won t open at the end of the cycle then the lock mechanism may be at fault. Nothing in none of the stages.