How do you straighten a garage door that is uneven on one side by about 1 inch.
Garage door closes unevenly.
Move the spring within the track hanger.
Check that the door closes evenly.
Adjust the lift cable.
One of the most likely culprits when you have a crooked garage door is a broken torsion spring.
While many problems that keep the door from opening are caused by broken springs a lot of other parts could be keeping your door from functioning properly.
This is when we will break out our super deluxe fix all bottom seal.
If there is a little gap at the bottom of your garage door on one side or your garage door has been jerking back and forth it s probably because there s uneven tension from the springs.
There are a lot of things that feel a little uneven in your life and your garage door shouldn t be one of those things you re still trying to balance at the end of the day.
It is possible that the vertical track down the side has gone out of alignment and shifted due to a slightly loose lag screw.
A problem with the spring tension could cause the door to open or close unevenly improperly or at the wrong speed and adjusting the springs will likely solve the problem.
The springs fatigue close to the same rate so even though both springs have the same rating the older spring has probably lost some of its strength.
Yes we have that to close the gap.
Your garage door has two overhead springs some doors have the springs on the side called extension springs that are responsible for opening and closing the door.
Garage door springs offset the weight of the door and allow it to open and close with ease.
One of these is.
The factory seal that came with the door may simply need to be replaced u but if the ebb and flow of the garage floor has created a gap wider than the factory seal can effectively cover then we ll go a separate route.
This page should help you troubleshoot your garage door problems.
By pushing the door back into position you should have made the vertical track straighten.
Brace the open door.
On both sides there should be a spool that has wire rope attached to it that also connects to the bottom of the door.
The springs should only be stretched about 1 inch or so when the door is open.