Garage Door Alignment Do It Yourself

Adjusting the tracks for a binding garage door step 1 loosen the track screws.

Garage door alignment do it yourself.

If the garage doors bind or are hard to move up or down in the tracks use a screwdriver to loosen the screws that secure the tracks to the garage door frame. If you are having problems with your sensors they may be out of alignment. A garage door sensoris an important safety feature that needs to work correctly. If you re adjusting the tracks on an automatic garage door disable the garage door opener before you start working.

Move the garage door up and down until you find a place where the door stays suspended when you let go. Using a screwdriver loosen the screws which hold the tracks in the garage door frame. Garage door alignment problems can cause you a lot of frustration. Step 2 moving the garage door sensor.

If that point is more than four feet or less than three feet above the ground you will need to balance the door. Use a spirit level to identify when the track is back in vertical alignment. For most doors you can do this by simply pulling the emergency release handle located near the front of back of the overhead track. Fortunately with the instructions above your garage door alignment problems can be an open and shut case.

Always turn off the power when working on the sensors. Turn off the garage door opener if necessary. Step 1 before you start the alignment process. If you need a new garage door you ve come to the right place.